UNI-T UT211 Spécifications télécharger pdf (Page 14)

To measure DC and AC voltage, connect the Meter as follows:

1. Insert the red test lead into the V terminal and the black test lead into the COM

terminal.

2.Connect the test leads across with the object being measured. When the AC

voltage is higher than AC1.4V or DC voltage is higher than ±1.4V, the Meter will

automatically enter the voltages measurement mode.

The measured value shows on the display.

Input Impedance is around 10M .

When DC and AC voltage measurement has been completed, disconnect the

connection between the testing leads and the circuit under test, and remove the

testing leads away from the input terminals of the Meter.

Note

Model UT211: OPERATING MANUAL

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 29 30

Pas de commentaire

UNI-T UT211 Spécifications Page 14