UNI-T UT50C Spécifications télécharger pdf (Page 18)

Measurement Operation(6)

The AC current measurement has 3 measurement positions

on the rotary switch: 20mA, 200mA and 20A.

To measure current, do the following:

1. Turn off power to the circuit. Discharge all high-voltage

capacitors.

2. Insert the red test lead into the mA or 20A terminal and

the black test lead into the COM terminal.

3. Set the rotary switch to an appropriate measurement

position in A range.

4. Break the current path to be tested. Connect the red

test lead to the more positive side of the break and the

black test lead to the more negative side of the break.

5. Turn on power to the circuit.

The measured value shows on the display.

l If the value of current to be measured is unknown, use

the maximum measurement position (20A) and 20A

terminal and reduce the range step by step until a

satisfactory reading is obtained.

l When current measurement has been completed,

disconnect the connection between the testing leads

and the circuit under test.

Model UT50D: OPERATING MANUAL

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 35 36

Pas de commentaire

UNI-T UT50C Spécifications Page 18