UNI-T UT 4000 Series Manuel d'utilisateur télécharger pdf (Page 55)

UNI-T

UT4000 User Manual

Automatic Measurement

As shown below, the [MEASURE] button is the function key for auto measurement. Read

the following instructions to familiarize with all the powerful automatic measurement

functions of your UT4000.

Figure 2-25 Function keys of the sampling system (auto measurement)

Application Examples

The measurement menu of your oscilloscope is capable of measuring 27 waveform

parameters.

Press [MEASURE] to enter the parameter measurement display menu which has 4

options that correspond to function keys F1~F4. To operate any individual option, press

the assigned function keys [F1~F4] to enter the setup menu for that function.

You can measure voltage or time measurement. You can select with the “Customize

Parameters” option. To enter the menu press [F2] and select the required parameters with

the multifunction control knob, then press [SELECT] to confirm (you can display up to 4

parameters). You can also press [F1] and select “All Parameters” to show all voltage and

time measurement parameters of the current channel. To quit “All Parameters”, press

[CLOSE].

Example 1 : To display the measurement peak-to-peak value of CH2, follow the steps

below :

1. Press [CH2] to select channel 2.

2. Press [MEASURE] to enter the measurement functions menu.

3. Press [F2] to enter the measurement parameters options.

4. Turn the multifunction control knob to the peak-to-peak value.

5. Press [SELECT] to confirm, then press [CLOSE] to exit.

The peak-to-peak value is displayed in the left bottom corner.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 98 99

Pas de commentaire

UNI-T UT 4000 Series Manuel d'utilisateur Page 55