UNI-T UT58D Spécifications télécharger pdf (Page 21)

Model UT58D: OPERATING MANUAL

Note

l When continuity testing has been completed,

disconnect the connection between the testing leads

and the circuit under test, and remove the testing

leads away from the input terminal of the Meter.

E. Testing for Inductance (see figure 7)

Warning

Make sure the tested inductance is far away from the

high electromagnetic to obtain accurate reading.

( figure 7)

Inductance measurement has 4 measurement positions

on the rotary switch: 2mH, 20mH, 200mH and 20H.

To test for Inductance, connect the Meter as below:

1. According to the size of the tested object’s leads,

insert multi-purpose socket or test clip into the mA

and V terminal.

2. Set the rotary switch to an appropriate measurement

position in HLx range.

3. Insert the tested object into the corresponding jack

of the multi-purpose socket or connect the test clip

to the object being measured.

The measured value shows on the display.

Measurement Operation(8)

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 33 34

Pas de commentaire

UNI-T UT58D Spécifications Page 21