UNI-T UT2000 series Guide d'installation télécharger pdf (Page 26)

5. Chapter Four: System Prompts and Troubleshooting

System Prompts

Time out prompt: Check the serial configuration or check whether the equipment is

properly connected.

Time out prompt: Check the USB configuration or check whether the equipment is

properly connected.

SCAN prompt: SCAN will perform single transmission. Please carry out single refresh.

Continue?

Are you sure you want to exit Virtual Instrument? A prompt will ask you if you wish

to close the software.

Troubleshooting

1. If the system prompts you to check serial or USB configuration when you enter

[Equipment ON/OFF], take the following steps:

 Check whether the oscilloscope power plug is properly connected.



Check whether oscilloscope ports match the testing and control software setups

(Factory default: RS-232 baud rate 4800).



Check whether the cable connection between module and PC is in order.



After carrying out the above checks, restart the software to continue operation.

In this direction will find a vision of the measurement technique:

http://www.industrial-needs.com/measuring-instruments.htm

NOTE: "This instrument doesn’t have ATEX protection, so it should not be used in potentially explosive

atmospheres (powder, flammable gases)."

1 2 ... 21 22 23 24 25 26

William Perales 27 Jan 2025 | 21:14:07

Me gusta este manual

UNI-T UT2000 series Guide d'installation Page 26